KrosFlo.

FilterChat.com:   The Answers for All of Your Filtration Questions.


Close MessageUserDate(yyyy-mm-dd)
Previous Subject
Next Subject		 fluxMacmo2007-01-03Click here to register.
What is the typical flux (L/m2Hr) I can expect from the 5.1 m^2 KrosFlo K20S 300 01P filter with tap water or surface water?
 
Re: flux
matthewr2007-01-09Click here to register.
Rejection criterion for LMH for our 50nm PS Fiber is 1200 LMH @ 10psi or 120 LMH / psig. (Thus, all fiber that is put into finished good performs this well or better)

Therefore, you can expect a water flux of about (120 LMH * 5.1 m2 * 1 h = ) 612 Liters of water / Psi of Transmembrane pressure ( TMP = (inlet - outlet Pressure)/ 2 - Permeate Pressure) for distilled water. I would expect very similar performance with tap water...surface water may vary depending on where it is from (i.e. increased liklihood of fouling)...

what is your specific application? mre@spectrumlabs.com

Thanks for visiting.
  • To ask or answer a question, you need to register here.
  • You can browse by clicking on a message subject to see the complete message.
  • You can also search the messages on this board below.
  • If you have previously registered, you can log in below.

Message (click on a subject to view the messages)
Click for older messages
OlderOlder LastOldest
Click for newer messages
NewestFirstLastNewer
Search for messages that contain  

You must register before asking a question or providing an answer.
You can click here to register. If you have already registered you can log in below.
(If you check the Use Cookies box then your computer will remember your log in name.)
User Name:
Password:


Click here if you previously registered and remember your user name but not your password.
Email us at drdavemc@lplc.com if you are having other problems.


Back to Top
All the Perl that's Practical to Extract and Report